b'23ReseneKermit 4Step 4Take the milk container, and cut down either side of the handle starting at the top. Cut the bottom off. Cut into horizontal strips about 3-4cm wide starting from the lower edge. You should get five strips from the lower part of the container thenanothercouplefromthetoppart. Fringe all the strips with the scissors, leaving51cm along the top of each strip for gluing.Step 5Paint the fringed strips using a mix of coloursResene Hi Jinx, Resene Rocket,ReseneBrightSparkandResene6Neva. Allow to dry thoroughly.Step 6Carefully glue the fringed strips around the top of the container with a hot glue gun, starting above where the greenpaintends.Coverthegluededge with the next layer of fringing, until you reach the top.Step 7 Paint the handle area in Resene Dizzy Lizzy, then insert the dowel through7thesmallerholessotheresthesame amount poking out on each side. Loop the handle through and hang it up in a tree!Resene Hi Jinx'