b'Stirrer tagsStep 3 You will need: ResenepaintstirrersWait for the paint to dry thoroughly, Resenetestpotinthen take the cards to be laminated.Resene Grass Stain Measurea1cmborderroundeach,and a fine paintbrushthen cut them out.Pen,rulerandscissors Furnituretacksandhammer PlasticplanttagStep 1Step 4 Measureoutarectangleof2.5cmx 3.5cm from the picture part of the tag Use the hole punch to make a hole inand cut it out. Turn the Resene paint the centre of the top and bottom ofstirrer to the unprinted side, with the each card, then run the cane throughflat end at the top, and nail the plastic the holes as shown. tag to the top of the stirrer as shown.For the seed packet labelsMeasure three rectangles of 13.5cm x 10cm on the white card and cut them out. Cut out the front of the seed packet from the seeds you are raising and measure a rectangle of 6cm x 9cm around the name and picture. Cut out. Glue the seed packet on to the white card as shown.seed packet using the Resene testpots.Step 2Paint rough brushstrokes around each Repeat steps 3 and 4 for the hand-painted vege labels to finish. Handprintincapitalletters,the matching name of the herb onto the stirrer, then use Resene Grass Stain to hand paint the letters onto the stirrer. styling and wordsHelena DunnpicturesMark Heaslip77'