Feedback
Resene Paints - home page

Home tweet home


Mark Rayner builds a bird house.

You will need: A piece of 22mm plywood: 200mm x 260mm (for the base),

Also required: exterior PVA glue, galvanised or stainless steel hinge, drill with 1.5mm, 12mm and 40mm size bits, 40mm galvanised jolt head nails, 19mm galvanised flat head nails, circular saw, sandpaper, set square, tape measure, hammer, paintbrush, pencil, Resene Quick Dry waterborne primer undercoat and Resene Lumbersider tinted to Resene Colonial White and Resene Green House.

Top tip: To keep the house safe for birds we used untreated materials, so make sure the plywood is primed and painted thoroughly for maximum protection from the elements.

To get the look: Mark stained the background fence with Resene Woodsman Penetrating Oil Stain tinted to Resene Bamboo.

Kiwi Gardener logo

Step 1 how to build a bird house

Step 1
Measure pieces of plywood to fit the above dimensions. Use the set square’s corner to mark the pitch of the gable roof on the front and back walls - the sides should each measure 250mm.

Step 2 how to build a bird house

Step 2
Cut out the plywood pieces with a circular saw and smooth rough edges with sandpaper. When cutting out one side of the awning, the saw blade will need to be set at 45° so it slopes down when attached.

Step 3 how to build a bird house

Step 3
Drill a few 12mm holes in the base, then a central 12mm hole 100mm up from the bottom of the front wall and lastly, a 40mm hole 20mm above this. Insert and glue the dowel in the smaller hole.

Step 4 how to build a bird house

Step 4
Prime all pieces with a coat of Resene Quick Dry and leave it two hours to dry.

Step 5 how to build a bird house

Step 5
Attach front, back and side walls, fixing along each edge with 40mm nails and PVA glue. With nails and glue, attach the base front shelf edge to the base and then the house to the base.

Step 6 how to build a bird house

Step 6
Drill 1.5mm pilot holes and then nail, with 19mm nails and glue the awning in position. Paint the birdhouse interior with two coats of Resene Green House, allowing two hours for each coat to dry.

Step 7 how to build a bird house

Step 7
Nail and glue roof panel 1. to one side of the gable. Attach roof panel 2. to this with the hinge and screws. Paint the birdhouse exterior with two coats of Resene Colonial White.

Step 8 how to build a bird house

Step 8
Paint the upper side of the roof, the base, awning and perch with two coats of Resene Green House, allowing two hours for each coat to dry.

View more projects

 
 

Get inspired ! Subscribe      Get saving ! Apply for a DIY card

Resene Paints Ltd

Can't find what you're looking for? Ask us!

Resene Paints Ltd   – www.resene.com

Videos on how to paint and stain your house

Colours shown on this website are a representation only. Please refer to the actual paint or product sample. Resene colour charts, testpots and samples are available for ordering online.   See measurements/conversions for more details on how electronic colour values are achieved.