Close Give Feedback
Resene Paints - home page
Follow us on Facebook Follow us on Pinterest Follow us on Instagram Follow us on YouTube

Propagation station

DIY project from NZ Gardener magazine

Grow stem cuttings in water with Jacob Leaf’s simple hanging propagator.

A simple hanging propagator

You will need

Cost: $20 excluding Resene product.

Instructions

 

Step 1 Step 1
Trim the 40mm x 10mm radiata moulding to 280mm in length. From one end, mark pilot holes at 40mm, 90mm, 140mm, 190mm and 240mm, then drill the holes with a 4mm drill bit.


Step 2 Step 2
Secure the radiata moulding, then with a 25mm spade bit, carefully drill out the holes for the test tubes.


Step 3A Step 3A
Measure in 10mm from each end of the wood and drill holes for the string hanger with a 4mm drill bit.


Step 3B Step 3B
Sand off any rough edges, then paint or stain.


Step 4 Step 4
Thread the string, then secure it in place with a stop knot at each end.


Step 5 Step 5
Slide the test tubes in place, then hang up your propagation station.


Watch the DIY video, “hanging plant propagator” at play.stuff.co.nz.

Download a PDF of this project

View more projects

 

Order online now:
Testpots | Paints | Primers and Sealers | Stains | Clears | Accessories

Get inspired Get inspired ! Subscribe      Get saving Get saving ! Apply for a DIY card

Resene Paints Ltd

Can't find what you're looking for? Ask us!

Resene Paints Ltd   – www.resene.com

Follow us on Facebook Follow us on Pinterest Follow us on Instagram Follow us on YouTube
Videos on how to paint and stain your house
 

Colours shown on this website are a representation only. Please refer to the actual paint or product sample. Resene colour charts, testpots and samples are available for ordering online.   See measurements/conversions for more details on how electronic colour values are achieved.

What's new | Specifiers | Painters | DIYers | Artists | Kids | Sitemap | Home | TOP ⇧